CNC X500 Drone Frame CNC STP Files

This file contains all the files required to print your own X500 drone frame at home.

Total Printing Volume of all 14 Files: 37,902 mm³

This file contains 10 files i.e.

5 .STL files for 3D printing.

1. 10mm pipe Holder.STL
2. Bottom Plate Connector.STL
3. Connector.STL
4. Landing Gear Bottom Mount.STL
5. Landing Gear Mount.STL

5 .STP files for CNC cutting.

1. Back Plate.STP
2. Bottom Plate.STP
3. Middle Plate.STP
4. Motor Plate.STP
5. Top Plate.STP

The X500 drone frame is distributed into the above-mentioned parts so that you can easily print any part at your home with your own DIY 3D printer of minimal size i.e. 220(mm)x220(mm)x250(mm).

To make your own homemade 3D printer at home see the blog below.

Homemade 3D Printer | Simple DIY Under $150

All the files given are complete and have been tested.

The print volume of all files (approximately):-

1. 10mm pipe Holder

   • Size – 10 x 25 x 19 (mm)
   • Volume – 2,928 mm³

2. Bottom Plate Connector

   • Size – 10 x 84 x 44 (mm)
   • Volume – 9,958 mm³

3. Connector

   • Size – 33 x 33 x 15 (mm)
   • Volume – 4,336 mm³

4. Landing Gear Bottom Mount

   • Size – 34 x 34 x 49 (mm)
   • Volume – 11,152 mm³

5. Landing Gear Mount

   • Size – 27 x 38 x 40 (mm)
   • Volume – 9,528 mm³

PDF files are also attached in the ZIP folder to make the installation easier.