This is a quadcopter tank that not only flies but also runs on land. It is completely 3D printed and assembled. It has a real-time open HD camera that provides real-time footage. It has track belts for moving in off-road conditions. This drone is for the hobbyist who likes to make cool stuff.
If you don’t have a 3D printer and would like a fully assembled model or a kit, send me a message and I’ll be more than happy to discuss 🙂
Checkout the Youtube Video
Recommended Electronics
Drone System
| Motor ×4 | Racerstar 2500Kv link DYS Sunfun 2500Kv link Samguk 2500Kv link |
| Propeller ×2pair | 6045 Tri Blade link 6042 Tri Blade link 6030 Tri Blade Folding link 5055 Tri Blade link 5152 Tri Blade link 51466 Tri Blade link 5135 Tri Blade Folding link |
| ESC ×4 | BLHeli 35A/45A link |
| Flight Controller | CUAV Nano 7 link Radiolink Pixhawk link |
| Transmitter & Receiver | 10 Ch FS-i6S link |
| Power Distribution Board | 100A PDB link Matek PDB link |
| Battery | 4S 3300mAh 60C link |
| Battery Charger | Sky RC B6 Neo link Imax B6 Balance link Imax B3 Pro (2S 3S) link |
Tank System
| Buck Converter | LM 2596 link |
| Gear Motor ×2 | 9V 150 RPM link |
| Motor Driver | L298 link |
| Microcontroller | Arduino Nano link |
Additional Electronics
| Power Module | CUAV 60A link Hollybro PM link Pixhawk PM 90A link |
| GPS & Compass | Ublox Neo7 link CUAV C Compass link |
| Telemetry | 915Mhz link |
For FPV Video Transmission
| Video Transmitter | Analog VTx link |
| Video Receiver | Analog VTx link |
Note :-
OpenHD is a complex system and requires an experienced person to deal with. If you want a hassle free and economic option then go for the above mentioned analog FPV Transmission or you can take the risk and work on the digital transmission OpenHD
OpenHD Air Unit
| Pi Zero | Pi Zero W link |
| Camera | 5MP Pi Camera link |
| Flex Cable | Cam Flex Cable link |
| Switch | Rocker Switch link |
| Buck Converter ×2 | LM 2596 link |
| USB Connector | Female USB link |
| SD Card | 32GB Micro SD link |
OpenHD Ground Unit
| Raspberry Pi | Pi 4 (4GB) link |
| Display | 7” Wave Share link |
| BMS | 2S 20A link |
| Buck Converter | LM 2596 link |
| Battery Cell ×2 | 18650 Rechargeable link |
| Cell Holder | 2 Cell Case link |
| Switch | Rocker Switch link |
| Antenna ×2 | AC1300 T3U Plus link |
Necessary Accessories
| 3D Printer | 220×220×250 mm build volume |
| Nuts and Bolts | M2.5, M3 size of various lengths |
| Accessories | Cable zip tie, heat shrink tube, soldering iron |
Reviews
There are no reviews yet.